Button fabric covering - spare package (without tool)
A pack contains 100 sets of buttons for covering (with aluminum upper parts and plastic lower parts). The hand tool is NOT included.
This product is suitable for those who already had an application kit and ran out of buttons, or for those who possess the suitable die set for press machines.
Please note that each size of buttons has its exclusive die set and hand tool. There is no one size fits all.
The contents of the kit are of top quality material and stainless.
8 size options are available.
Black and white color options are available for the plastic lower parts.
SUPPORTED INDUSTRIES
• Hobby works
• Accessories and ornaments
• Home textile
• Quilts and bed covers
• Coats, jackets, and blazer jackets
• Hats and caps
• Shoemaking
• Outerwear
• Knitwear
• Cushions and furnitures
TIP for properly arrange the size of your fabric which will be used in covering the button;
! Put your easy-to-use tool on top of the fabric you want to cover. Use a pencil or soapstone to draw a circle around the tool, then cut the circle-shaped marked fabric about 1-2 mm away from the circle you drew.
Please mind the suggestions below before your application;
1- Your covering material must not be too thick such as leather, brocade or fabric for upholstery.
2- Please mind the suggested size to cut your fabric. Cutting it too big or too small might end up in failure to cover the button.
3- Putting an interlining below the fabric is suggested while using very thin or slippery fabrics.
4- While punching the tool with hammer, a blow too weak might cause your button to fell apart, while a blow too strong might cause deformity on the aluminium upper part of the button. A few trials are encouraged before starting your project.
APPLICATION VIDEOS:
SIZE GUIDE: Line / mm
The dimensions are for the aluminum cap part of the button before covering.
18’’ : 11.5 mm
20’’ : 12,5 mm
24’’ : 15 mm
28’’ : 18 mm
32’’ : 19 mm
36’’ : 23 mm
40’’ : 25,5 mm
44’’ : 28 mm
EN − TL
